WAGNER Super Finish 33 Pro User Manual (English)

Other manuals for WAGNER Super Finish 33 Pro

Questions and Answers:

S
Stephen MartinAug 14, 2025
Why is the delivery rate too low on my WAGNER Paint Sprayer?
- H
  Hannah RussellAug 14, 2025
  If your WAGNER Paint Sprayer's delivery rate is too low, it could be due to damaged inlet or outlet valves; inspect and replace them if necessary. Another cause could be that the unit is sucking in air; check the suction system, inlet valve pusher, and gaskets inside the inlet valve. Also, ensure the suction filter isn't clogged and that the material's viscosity isn't too high. If needed, check the valve lift for inlet valve 341247 (2.4 mm).
D
David CabreraAug 17, 2025
How to fix WAGNER Super Finish 33 Pro Paint Sprayer that does not start?
- J
  Jessica RiveraAug 17, 2025
  If your WAGNER Paint Sprayer unit won't start, the unit fuse may have triggered. Let the motor cool down. Another possibility is that the multi-function switch wasn't set back to '0' previously; set it to '0' and then switch it back on.
J
Jennifer MartinezAug 21, 2025
What to do if my WAGNER Paint Sprayer does not suck in?
- J
  Jessica EvansAug 21, 2025
  If your WAGNER Paint Sprayer isn't sucking in material, the issue might stem from a damaged or clogged inlet or outlet valve. Try replacing or cleaning these valves. Other potential causes include a leaking valve pusher (dismantle and replace if needed) or the unit not being properly ventilated (ventilate the unit).
C
carlsonjoeAug 25, 2025
Why is my WAGNER Paint Sprayer losing oil?
- L
  Lisa WilkinsonAug 25, 2025
  If your WAGNER Paint Sprayer loses oil, the gasket of the front cover might be defective; replace it with a Klingersil material gasket. Other potential issues include a blowhole in the front cover (check and replace if necessary), leaking O-rings of the insert in the pressure insert (disassemble the pumphead and replace the insert O-rings), a leaking diaphragm fixation (replace the diaphragm), a defective or missing seal between the pressure insert and hydraulic housing (check and replace), or a cracked pressure insert (replace).
S
Stephanie ManningAug 27, 2025
Why is material coming out of the paint head of my WAGNER Super Finish 33 Pro?
- M
  Melissa LevyAug 27, 2025
  If material is coming out of the paint head of your WAGNER Paint Sprayer, a sealing ring 341331 might be missing; mount the sealing ring. Alternatively, the paint head may be damaged by backwashing or, if it's an aluminum paint head (SF33 Pro), it might be cracked; in either case, replace the paint head.
E
Eileen CamposAug 31, 2025
Why does my WAGNER Super Finish 33 Pro Paint Sprayer trigger the mains fuse during start-up?
- E
  Edward ValdezAug 31, 2025
  If your WAGNER Paint Sprayer triggers the mains fuse during start-up, it's likely due to the device's high starting current in a cold state (approximately 48A). A 10A fuse is not suitable; use a 30m cable drum.
E
eflowersSep 3, 2025
Why does my WAGNER Super Finish 33 Pro make a strange noise when running?
- J
  John BradleySep 3, 2025
  If your WAGNER Paint Sprayer is running but making a strange noise, a gearwheel inside the gearbox may be damaged; replace the gear wheel, including the 8 sleeves, and remove any broken pins in the gear housing. Another cause could be a vibrating fan cover; tighten the screws of the fan cover. Alternatively, the transmission may be whistling; run it in for approximately 2 hours under load (spraying pressure with water around 200 bar); if there's no improvement, replace the internally geared gearwheel.
T
tylermillsSep 6, 2025
Why does the manometer on my WAGNER Super Finish 33 Pro Paint Sprayer show strong pulsation?
- L
  Lisa RobertsSep 6, 2025
  If the manometer on your WAGNER Paint Sprayer shows strong pulsation, the glycerine filling in the manometer might be too low (it should be approximately 5mm below the scale's top edge, around 95% full). Top it up with glycerine, using a disposable syringe to remove some from an old manometer if needed.
T
Toni FlynnSep 10, 2025
What to do if my WAGNER Paint Sprayer can't be ventilated?