14
English
Title
1
. Unplug the sprayer. Pour the remaining material back
into the original container.
2. Fill the container half full of the cleaning solution
appropriate to the type of material you sprayed (warm,
soapy water for latex materials, mineral spirits for oil-
based materials).
Move on to
Cleaning the Components
, page 16.
3. Reattach the container and plug in the sprayer. Squeeze
the trigger until the solution comes though the sprayer for
several seconds.
4. Unplug the sprayer. Press the Lock-N-Go™ buttons on
both sides of the sprayer with one hand, grab the cup or
pump with your other hand, and slide the spray cartridge
out.
5. Remove the container and properly dispose of the
remaining solution.
Cleanup for oil-based materials (fluid container)
6. Remove the suction set.
To Next Page
Loading...
Need help?
General
