WAGO-I/O-SYSTEM 750 Configuring via the Web-Based Management System (WBM) 113
750-363/0040-0000 FC EtherNet/IP G4 ECO XTR
Manual
Version 1.0.0
9.2 Open WBM
1. To open the WBM, launch a Web browser.
2. Enter the IP address of the fieldbus coupler/controller in the address bar.
3. Click [Enter] to confirm.
The start page of WBM loads.
4. Select the link to the desired WBM page in the left navigation bar.
The first time a configuration page is called, a login dialog appears
5. Enter your user name and password in the query dialog (default: user =
“admin”, password = “wago” or user = “user”, password = “user”).
The corresponding WBM page is loaded.
6. Make the desired settings.
7. Click [SUBMIT] to confirm your changes or click [UNDO] to discard the
changes.
At the first confirmation via the [SUBMIT] button, a login dialog appears
again. Proceed as described under point 5.
8. To apply the settings, you may have to reboot afterwards if this is indicated
in the description text on the respective WBM page.
You restart the system using WBM page “Administration”, button
[SOFTWARE RESET].
To Next Page
Loading...
Need help?
General
