Need help?Do you have a question about the WAGO 750-489 and is the answer not in the manual?
General| Brand | WAGO |
|---|---|
| Model | 750-489 |
| Category | Control Unit |
| Language | English |
Provides essential safety precautions for installation and operation, including electrical safety.
Details technical specifications including device data, power supply, and communication.
Details input types, measurement ranges, resolutions, and conversion times.
Provides technical data related to explosion protection requirements and parameters.
Provides an overview of supported sensor types and their data representation.
Details formulas for converting process values for temperature, resistance, and voltage.
Details temperature measurements using Celsius, including standard and S5-FB250 formats.
Details temperature measurements using Fahrenheit, including standard and S5-FB250 formats.
Details temperature measurements using Kelvin, including standard and S5-FB250 formats.
Details high-resolution temperature measurements in Kelvin for RTD/TC sensors.
Explains resistance measurements in standard and S5-FB250 formats, including resolutions.
Details resistance measurement for the 0-250 Ohm range in standard and S5-FB250 formats.
Details resistance measurement for the 0-500 Ohm range in standard and S5-FB250 formats.
Details resistance measurement for the 0-1 kOhm range in standard and S5-FB250 formats.
Details resistance measurement for the 0-2 kOhm range in standard and S5-FB250 formats.
Explains voltage measurements in standard and S5-FB250 formats, including resolutions.
Explains how to configure and parameterize the I/O module using WAGO-I/O-CHECK software.
Describes I/O module behavior based on diagnosis configuration and error priority levels.
Details installation regulations and special notes for electrical equipment in hazardous areas.
Explains how to update or downgrade firmware on Series 750 I/O modules.
To Next Page
