21
Steps to use:
①Set shooting parameters, including shooting interval and composite video duration. The screen will display the
number of shots and the shooting time.
②Click the shooting button to start shooting.
TimeLapse
Lock Assist: The Lock Assist functions include Cruise Control Mode, Target Lock Mode, Circle
Mode, Rise(Soaring to the Sky) Mode, Far Away(Fading) Mode, Drift(Tail Flick) Mode, etc.
Free( FreeTime-Lapse)
By setting parameters, the aircraft will automatically take a certain number of photos within the set time and generate
time-lapse video. When not taking off, it can shoot on the ground; when taking off, users can freely control the
aircraft and gimbal angle with joystick and somatosensory control.
Circe Follow
After entering the Follow Mode, manually adjust the aircraft position and gimbal pitch, the recommended height
is 20 meters, and the distance to the WK-V8 controller is 40 meters. Select an open place without obstacles and
click the Circle Follow button on the App interface. The aircraft will fly in a Circle Follow mode during Intelligent
Accompany Flight, with the WK-V8 controller as the center and the gimbal automatically aligned with the target.
Press the B button on the WK-V8 controller, and the aircraft hovers in place, which can interrupt the Circle Follow
flight.
Four-Corner Follow(Quadrangle follow)
After entering the Follow Mode, manually adjust the aircraft position and gimbal pitch, the recommended height
is 20 meters, and the distance to the WK-V8 controller is 40 meters. Select an open place without obstacles and
click the “Four-Corner Follow(Quadrangle follow)” button on the App interface. The aircraft will hover and shoot at
the front left, front right, rear right, and rear left of the WK-V8 controller while doing follow flying, with the WK-V8
controller as the center and the gimbal automatically aligned with the target. After the execution is completed, it
will keep the Follow Mode. Press the B button on the WK-V8 controller, and the aircraft hovers in place, which can
interrupt the Four-Corner Follow flight.
Cruise
Automatically maintain three-dimensional movement and spin speed, click the Cruise button on the App interface
while manually flying the aircraft, and the flight control will automatically maintain the current climb speed, horizontal
flight speed, and spin angle speed, and maintain the movement of manual flying at a constant speed, bringing a
new play of camera movement. Click the Cruise button again or push the throttle joystick to the highest, to cancel
the Cruise flight.
Target lock (target waypoint marking assisted camera movement):
In the flight process, adjust the gimbal to be aligned with the ground target, click the Target Lock button on the App
interface, to open the target waypoint marking function, and view the target’s latitude, longitude and height coordinates
and distance. The gimbal is automatically and continuously aligned to lock the target, then the gimbal pitch and
aircraft heading turn to automatic control state. At this point, it cannot be manually adjusted, instead, you can operate
the joysti
cks to adjust the height and horizontal position of the aircraft. The gimbal can automatically lock the target
while the position changes. To mark the waypoints for targets above the ground such as buildings, it is required to
fly the aircraft to the top of the target, control the gimbal pitch towards the bottom, adjust the height of the aircraft
to be 20 meters above the top of the building, then press the Target Lock button, and the gimbal will lock the position
20 meters right below the aircraft. Click the Target Lock button again, to cancel the gimbal lock.
Circle:
After locking the target, click the Circle button on the App interface, and the aircraft will be aligned with the target
and keep circling. When it reaches the time limit or the Circle button is clicked again, the Circle flight will be canceled.
Walkera All Rights Reserved
T210 MINI(WK-V8)Operation guide
To Next Page
Loading...
