To Next PageTo Next Page
Need help?Do you have a question about the wallas 30 GB and is the answer not in the manual?
Key considerations for choosing the installation site for the heater.
Protection and routing advice for power cables, warm air ducts, and fuel hoses.
Guidelines on the physical space needed for installing the heater.
Recommendations for making connections easier for service and mounting.
Tips for minimizing current losses and ensuring proper cable sizing.
Table detailing cable size based on power cord length.
Requirements for installing a main switch for the device.
How to connect the device to a 12V DC power source.
How to connect the device to a 24V DC power source.
How to check the voltage at the quick coupling during startup.
Advice on fuel hose length, filter placement, and material compatibility.
Notes on country-specific fuel hose and filter regulations.
Details on fuel feed adjustments and system requirements.
Requirements for connecting to a fixed fuel tank.
Instructions for connecting to a separate fuel tank.
Installation of the 30015 fuel filter.
Installation of the 30014 fuel filter for cold conditions.
Installation of the 30016 fuel filter for metallic transfer systems.
Recommended installation scenarios for the solenoid valve based on fuel level.
Types of exhaust gas lead-throughs for 22/30 GB and 40 Dt models.
Guidelines for location and installation of exhaust lead-throughs.
Advice on placing exhaust lead-throughs relative to fuel filler and water.
Installation tips for exhaust lead-throughs, including goose neck use.
Important considerations for exhaust gas pipes and drainage locks.
Requirement for insulation kits in metal-hulled boats.
Specific insulation kit for coaxial lead-throughs.
Specific instructions for installing the 2467 side lead-through.
How to maintain the seals of the closable lead-through.
Instructions for side installation of the 40 Dt exhaust lead-through.
Instructions for deck installation of the 40 Dt exhaust lead-through.
How to install air ducting into the engine compartment.
How to distribute heated air using ducts and registers.
How the heater takes in air for heating, including options for fresh or cabin air.
Advice on ducting runs to optimize performance and minimize heat loss.
How to install the 3411 air register in a bulkhead.
How to install the 2411 air register in a bulkhead or wall.
Ensuring proper ventilation, exhaust outlet placement, and switch installation.
Steps for installing the fuel system, including filters and hoses.
Guidelines for connecting the 12V DC power supply and fuse.
Notes on exhaust outlet location and hull insulation.
Restrictions on reducing warm air hose diameter and insulating warm air hoses.
Steps and tips for the initial startup process of the heater.
How the heater ignites and the indicator lights during startup.
How to adjust heat using thermostat or manual control.
How the heater operates in thermostat mode.
How the sun-switch automatically shuts down the device.
How to adjust the heater's power manually.
How to activate air boost for increased air volume.
How to activate, deactivate, and adjust ventilation.
How to safely shut down the heater.
Information on controlling the heater via remote control.
Explanation of the different indicator light colors and their meanings.
Recommended basic maintenance for diesel-operated devices.
Advice on periodic use, fuel type, and water removal.
Steps for preparing the device for winter storage.
Where to find a list of spare parts.
General
