Need help?Do you have a question about the wallas M40 and is the answer not in the manual?
Guidelines for positioning the heater, ensuring adequate clearance and ventilation for safe operation.
Instructions for placing the fuel tank, including hose length, protection from sunlight, and pipe requirements.
Recommendations for placing the battery, considering wire thickness, fuse protection, and safety.
Steps for installing ducts and pipes through walls, including specific measurements for openings.
Procedure for installing the heater using a duct system, considering air flow and potential condensation issues.
Details on alternative fuels, their temperature limits, and suitability for combustion in the heater.
Step-by-step guide for the first start-up and normal start-up of the heater, including signal light behavior.
Explanation of the LED indicator lights on the control panel and their meanings during operation.
Checklist for common service failures like fuel not moving, no voltage, or under-voltage.
Overview of fuel consumption, thermal power, operating voltage, current, and dimensions.
Procedure for cleaning the burner, removing crust, and replacing components like the fuel needle.
Steps to verify the burner and heater are functioning correctly after servicing, checking flames and heat radiator.
Procedure to measure and adjust fuel feed for optimal heater performance, checking consumption.
Diagram and explanation of connections on the main electronics card for various functions.
Instructions for connecting accessories like remote controls, thermostats, and timers to the heater.
To Next Page
General
