EasyManua.ls Logo

walser Walimex Pro Operator - Important Safety Information

walser Walimex Pro Operator
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
2. Important safety information
WARNING
Danger of electric shock, burn hazard
Please note, that the device is still connected with the supply voltage even
ifitisswitchedo󰀨.Justafterdisconnectingthedevicefromthepowersup-
ply through pulling out the power cable, the device is actually de-energized.
Disconnect from power supply by unplugging the power cord before
starting any maintenance arrangements.
Disconnect from power supply by unplugging the power cord when the
device is not in use for a longer time.
WARNING
Dangerofelectricshock,rethroughshort-circuit
A short-circuit could be caused through defect cables and through humidity
or moisture. A short-circuit can warm up the conductors, so that there isola-
tionwillmeltorevenmeltthoroughly.Thiscouldleadtore.
Don´t operate the device with wet hands or feet.
Please only follow this instruction manual for cleaning the device.
Make sure, that cables and conductors won’t be damaged. Damages
couldbecausedthroughheatimpact,chemicalinuenceorthrough
mechanical impacts as rubbing, bending, tearing, rolling over or nibbling
animals.
Prevent your device from falling down.
Incaseoffalling-o󰀨,pleaseletanelectriciancheckthedevicebefore
switching on again.
If your device should be damaged or defect or if you notice a burning
smell:
Disconnect the power supply by pulling out the power cord immediately.
Never operate your device with damaged housing, defect lamps or
damaged power cord. Don´t open the receiver. Never repair the device
on your own. The device should only be repaired by electricians.