walser Walimex Pro Operator - Solve Problems

21
8. Solve problems
Problem Possible reason Remedy
Remote Trigger
has no function
Studioashis
switchedo󰀨
Switchonstudioash
Flash or Camera
do not trigger
The frequency between
transmitter and receiver
is not the same
Please adjust the same
frequency on both devices
Battery on receiver is
too weak
Change battery,
see Change battery
Sync cord/Flash mount
not connected correctly
Checksynccord/ash
mount connection
NOTE
Payattentiontoelectromagneticelds,whichcanbecaused,e.g.,byradio
receiver devices or radio remote devices. These can cause malfunctions.
Change batterie
WARNING
Pleasejustusebatteries,whichcomplywiththerequiredspecications.
See Technical Specications.
1. Use a screwdriver to loose the screw on the bottom side of the transmitter.
2. Takeo󰀨thetopsideofthehousing.
3. Change the battery. Pay attention to the right polarity.
4. Screw up the housing again.