1. Lower the platform in the open position to
the ground and cut power to the liftgate.
Unbolt the switch from the runner.
2. Remove the hose cover by removing the 2
bolts and cutting the 3 wire ties that hold
the switch wire in place.
3. On the cover you also need to remove the
bolt holding the bracket securing hose to
the cover.
4. With cover removed, disconnect the hoses from the cylinder and disconnect the
bolts holding the brackets that secure the hose to the inside guard.
5. Disconnect hoses and wire connection under the trailer. The new switch or
hoses or combination of both are ready to install.
To Next Page
Loading...