Walter SURFOX 305 - Default Chapter; Table of Contents

SURFOX 305 User’s Guide 1
Table of contents
Table of contents
1 Introduction 2
2 Safety instructions 3
3 Equipment controls 4
A) Control panel pictograms 4
B) Front and back view of the machine 5
C) Wand control buttons 6
8 Using the marking/etching wand (optional) 12
A) Marking kits 12
B) Selecting the proper mode 12
C) SURFOX testing devices 12
9 Neutralizing 13
A) Directions for neutralizing SURFOX
pads and tips
E) Plugging in the power cord 8
6 Using the hand wand to electrochemically
clean, polish and passivate 9
A) Selecting the proper mode 9
C) AC/DC current basics 17
D) AC/DC settings on the SURFOX machine 18
E) Welds that cannot be cleaned 18
12 Technical data 19
B) Selecting the proper current type,
AC or DC on stainless steel
9 13 Warranty and service 19
A) Warranty policy 19
B) Repair and service 19
10
10
11
C) Selecting the proper current type,
9
AC or DC on stainless steel
D) Selecting the proper pumping mode
9
E) Cleaning and passivating
9
F) Neutralizing
9
7
Using the mini wand (optional) to clean
and passivate
10
10
10
10
A) Selecting the proper mode
B) Selecting the proper current type,
AC or DC on stainless steel
C) Selecting the proper current type,
AC or DC on stainless steel
D) Selecting the proper pumping mode
E) Cleaning and passivating
F) Neutralizing
G) List of supplies and part numbers
10
D) Fume elimination system
6
electrolyte cleaning solutions 13
E) Fastening inserts on the large wand
6
B) SURFOX WELD cleaning and neutralization
4
Control panel
procedure
13
A) Main power switch
7
10 Accessories 14
B) Application Selector
7
A) Selection and mounting of the cleaning
C) Power selector
7
B) High conductivity cleaning pads 15
D) Electrolyte flow
7
C) PTFE clamp rings 16
5
Start-up procedure
8
D) SURFOX electrolyte solutions 16
A) Attaching the wand to the quick-connect
8
E) Mounting a cleaning pad 16
adaptor on the machine
B) Filling the tank and purging the line
8
11
Safety features
17
C) Connecting the air supply 8
A) Sparks on the tip/work piece
17
D) Plugging in the ground clamp 8
B) Internal temperature
17
15
7