Walther Systemtechnik GmbH – D 76726 Germersheim
Telefon: +49 (0)7274-7022-0 Telefax: +49 (0)7274-7022-91
http://www.walther-2000.de – info@walther-2000.de
3 Transport
3.1 Packaging
The type of packaging depends on the individual mode of shipping. If not separately contracted, the
packaging is in accordance with the rules and regulations of Walther Systemtechnik GmbH. This rule is in
accordance with the Federal Association for Packaging HPE.
3.2 Tasks before Transport
The following has to be done before transport:
Disconnect all power lines.
The actual transport of the device and its individual parts requires special care in order to prevent damages
from external forceful impact or careless on- and off-loading. Depending on the mode of transportation,
suitable transport and load securing has to be selected. The device will be aligned and leveled by
appropriate fastening elements.
4 Description of Function
4.1 Designated Use of the Incomplete Device
Dosing valves are used for the application of a pre-defined quantity of medium on certain selected parts. A
special drive technology (pneumatic/electric) will define and control the application time. The Dosing Valves
are also suitable for use with oil.
4.2 Type Label of the Incomplete Device
The Dosing Valve is marked on the side of the
housing by an engraving that contains the
production number, the article number, the max.
operating pressure and the dosing volume.
IMPORTANT
Please indicate the product information shown on the type label when ordering spare
parts or requesting technical support.
To Next Page
Loading...
Need help?
General
