Wang 2200 - Loading

Loading
a
New
Disk Cartridge
Step
1.
Make
certain
that the
disk
power
is
ON, and the START/ STOP switch
is
set
to
STOP
(START indicator
extinguished) . A disk
cartridge
cannot
be loaded
while the
disk is in
the START mode.
Step
2.
Disengage
the dust
cover
from the
disk cartridge
by
simply pushing
the
cover release
button
toward the center of
the cover.
Set
the
cover
aside,
storing it
with its
hollow side down
to
prevent
dust
collection.
Step
3.
Slide
the disk
cartridge
into the receiver track
with
a
sligjht
upward pressure
on the cartridge handle; be
sure that the head
opening
is toward
the rear of
the unit.
CAUTION
Do
not
apply
downward
pressure on the cartridge
while
loading
(refer
to
Figure
2-9)
.
The cartridge
will not
seat
properly and
damage
may result
to
the disk.
Step
4. Push
the
cartridge
rearward
until it
stops.
Step
5.
Close
the cartridge access
door.
The cartridge slides into
place
on
the
spindle
automatically as the access
door
is
closed.
Step
6. Set
the
START/STOP
switch to the START position to
apply
power to
the
spindle
motor.
NOTE
If
the spindle
motor does
not rotate, the disk cartridge
access
door may not be
completely closed,
the cartridge
may
not be
properly seated
on the spindle chuck,
or the
cartridge
receiver/base
may not
be
all the
way down the
lower
chassis.
15