©2011 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc. 4 88126A0
INSTALLATION INSTRUCTIONS
1. In step one locate the welded puck on your plow mount.
Insert the puck into the hole as shown in gure 1. Take one
of the hex head bolts and a at washer and insert it through
the the hole with the puck you inserted through the frame.
2. On the top side of the skid plate place the large black
washer over the bolt along with a at washer and lock nut.
Do not tighten yet but you can take some of the slack out of
the threads. See gure 2.
3. Locate and position the RH bracket a shown in gure three
over the top of the frame. Attach to the plow mount using
two hex head bolts four at washers and two lock nuts. Do
not tighten at this time. See gure 3.
Figure 1
Figure 2
Figure 3
WARNING
IMPACT AND MOVING PARTS ENTANGLEMENT HAZARD
Failure to observe these instructions could lead to severe injury or death
• Always remove jewelry and wear eye protection.
Read installation and operating instructions thoroughly.
To Next Page
Loading...
