OPERATION
11
OPERATION
WARNING
Read and understand entire Operator’s Manual for
each optional attachment used on this power head
and follow all warnings and instructions. Failure to
follow all instructions mayresult in electric shock,
fire and/or serious personal injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury
and will void any warranty offered.
WARNING
Any contact with the attachment cutting head can
result in burns and/or other serious personal injury.
WARNING
Read the safety information for safe operation when
using a blade attachment and refer to the safety
rules and instructions in your attachment manual.
Never use a brush cutter attachment withthis
electric powerhead. Improper operation of a blade
or any attachment could result in serious injury.
LOCK-OUT BUTTON
The safety lock-out button reduces the possibility of
accidental starting. The lock-out button is located on
the handle beside the switch trigger. The lock-out button
must be depressed before you pull the switch trigger.
The lock resets each time the trigger is released.
STARTING AND STOPPING THE TRIMMER
To start:
– Insert the battery pack into rear handle. (Fully
charge before first use)
– Depress the lock-out button and squeeze the switch
trigger.
To stop:
– Release the switch trigger.
OPERATING THE TRIMMER
Hold the rear handle with your right hand on the rear
handle and your left hand on the auxiliary handle. Keep a
firm grip with both hands while in operation. Rear handle
should be held at a comfortable position with the rear
handle about hip height.
Always operate rear handle at full throttle. If debris
becomes wrapped around the attachment, release the
switch trigger, and disconnect battery and then remove
the tangled debris.
TAP AUTOMATIC RELEASE
When the weeding rope is worn seriously and the
weeding efficiency is low, the button on the top of the
trimmer head can be knocked on the ground when
the machine is started to complete the automatic line
releasing action.
Tap this area
Lock out button
Trigger
To Next Page
Loading...
