What to do if 'Lamp data not found' error occurs on Waters Security Sensors?
If the 'Lamp data not found' error appears on Waters Security Sensors, recycle power to the detector. This action removes the error.
How to resolve 'Configuration not found' error on Waters Security Sensors?
If the 'Configuration not found' error appears on the 2489 Detector Waters Security Sensors, recycle power to the detector. This action removes the error.
What to do if the Waters 2489 Security Sensors lamp fails?
If the Waters Security Sensors lamp fails, first check the lamp icon. Then, recycle power to the detector. If the issue persists, replace the lamp.
How to troubleshoot lamp external input conflict in Waters Security Sensors?
If you are experiencing a lamp external input conflict with your Waters Security Sensors, check the contact closure status and timed events. Then, recycle power to the detector.
What to do for calibration or energy error on startup in Waters 2489?
If you get a calibration or energy error on startup with your Waters Security Sensors, remove the cuvette. Flush the flow cell, and perform a manual calibration.
How to resolve grating initialization failure due to high backlash on Waters 2489 Security Sensors?
If you encounter a grating initialization failure with backlash too high on your Waters Security Sensors, first recycle power to the detector. If the problem persists, contact Waters Technical Service. The issue occurs when the difference between the forward and reverse peak positions of deuterium at 656 nm is greater than 1 step.
How to fix a non-functioning keypad on Waters 2489?
If the keypad on your Waters Security Sensors is not functioning, recycle power to the detector and run the keypad diagnostic test. If the issue persists, contact Waters Technical Service.
How to resolve no sample and reference energy on Waters 2489 Security Sensors?
If there is no sample and reference energy in Waters Security Sensors, attempt to reignite the lamp using the Lamp key or replace the lamp. Check the lamp icon and run the Sample & ref energy diagnostic test.
Why is my Waters Security Sensors detector inoperative?
If the Waters Security Sensors detector is inoperative, check if the front panel display is working. If not, replace the AC rear panel fuse. Also, check the outlet by connecting another electrical unit to ensure it's providing power.
What to do for lamp lighting failure in Waters 2489?
If you experience a lamp lighting failure with your Waters Security Sensors, first recycle power to the detector. Next, check the lamp power connection. If the problem continues, replace the lamp.
General| Type | UV/Vis Detector |
|---|---|
| Wavelength Range | 190-700 nm |
| Light Source | Deuterium lamp |
| Drift | <1 x 10^-4 AU/hour |
| Flow Cell Volume | 10 μL |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Bandwidth | 8 nm |
To Next Page
