SmartPlate Installation, Operation & Maintenance Manual
CHAPTER 8 – CORRECTIVE MAINTENANCE
OMM-0069_0H • SP-100 • 1/30/2020 Technical Support • (800) 526-0288 • Mon-Fri, 8 am - 5 pm EST Page 74 of 134
Replacing Gaskets on Channel Plates Instructions
Figure 8-15. Clip-Type Glueless Gasket Installation
4. When the plates of the heat exchanger are assembled and tightened, the gasket provides
a tight seal around the plate.
5. Before closing the plate pack, check to ensure that the gasket prongs are in the correct
position.
8.8.2 REPLACING GASKETS ON END PLATE (FIRST PLATE AGAINST FRAME
PLATE)
Replacing Gaskets on End Plate Instructions
1. Obtain two standard plate gaskets (P/N 81128 for DW units).
2. Cut the gaskets as indicated in Figure 8-16, below.
3. Attach gasket to plate as indicated in Figure 8-17, below.
To Next Page
Loading...
