Watts WQC4RO - Adapt-a-Valve Installation

Page 6
Turn off the cold water supply to the faucet by turning the angle stop valve completely off.
Open cold water sink faucet to relieve pressure.
Step 5
Step 6
Choosing the conguration that ts your plumbing, attach the adapt-a-valve as illustrated in
the four photos above.
Adapt-a-Valve Installation
Do not use Teon tape with the Adapt-a-Valve.WARNING:
Caution:
Water supply line to the system must be from the cold water supply line only.
Hot water will severely damage your system.
Make sure that the black collet is installed in to the 1/4” opening on the Adapt-a-valve.
Don’t forget to install the white compression washer with the 3/8” conguration.
Brass adapter (A) does not need to be tightened with a wrench, only nger tight.
TIPS:
Mount the Reverse Osmosis Faucet
Refer to installation instructions found on faucet box.
If installing an Air-Gap faucet, connect tubes to the faucet prior to mounting:
1/4” Red Tube - Air Gap Feed
3/8” Black Tube - Air Gap Drain
1/4” Blue Tube - Drinking Water
(Use Provided Adapter if Drinking Water Connection is 3/8”)
D
B
Line from
Cold Water
Supply
Faucet
Connection
Faucet Line
Cold
Water
Supply
C
B
A
D
B
Line from
Cold Water
Supply
Faucet
Connection
Faucet Line
Cold
Water
Supply
C
B
A
For 1/2” Configuration
Parts List for Adapt-A-Valve
Item Description
A Brass Adapter with black washer
B Plastic Adapt-A-Valve & black collet
C White Rubber Washer
D Brass Adapter with no washer
For 3/8” Configuration