CLEANING YOUR WAVE SPA
Detergent residues and dissolved solids from bathing suits and chemicals will gradually accumulate in
the spa’s water. To clean your Wave Spa, use soap and water then rinse thoroughly. Please note: do not
use hard brushes or abrasive cleaners.
REPAIRING PUNCTURES IN YOUR WAVE SPA
If your Wave Spa liner is torn or punctured, use the repair patches provided. Completely dry the area to
be repaired, apply a strong adhesive to the repair patch and then cover the damaged area. Smooth the
surface to remove any air bubbles. Leave to dry for 12 hours before using the Wave Spa.
HOW TO EMPTY YOUR WAVE SPA
1. Firstly, remove the RCD plug from the electrical mains.
2. Remove the screw cap from the water outlet (below the pump system of the Wave Spa) ensuring the
Drainage Plug is still inserted to prevent unexpected draining.
3. Screw the hose onto the water outlet and direct the open end of the hose appropriately.
4. Remove the drainage plug from the outlet on the floor of the spa so the water can flow out.
5. When the Wave Spa is completely drained of water, you must operate the bubble function for 30
seconds to drain any remaining water from the pipeline.
6. When draining has finished, remove the hose and replace the drainage plug and water outlet cap.
STORING YOUR WAVE SPA
Make sure all the water is completely drained from the Wave Spa and pump system. This is vital in
extending the life of your Wave Spa. We recommend the use of a wet/dry vacuum to blow out or suck up
water from the Wave Spa pipes and pump lines. Remove the filter cartridge.
Your spa should be stored in a dry place, ideally raised off the floor and away from any extreme
temperatures. Please note: Plastic becomes brittle and susceptible to breakage when exposed to
subzero temperatures and this can severely damage your Wave Spa. Leaving your Wave Spa outside and
uncovered during the winter months will void your warranty.
CLEANING THE WATER FILTER CARTRIDGE & MESH FILTER
To maintain best performance, we suggest that you clean your filter after every use and, if using your spa
2-3 times per week, change your filter every week.
1. Remove the filter protector cover and then remove the filter cartridge.
2. The filter cartridge can be rinsed periodically under a cold tap and reused. However, if the filter
cartridge remains soiled and discoloured the filter cartridge should be replaced. If any holes are
present in the paper filter or the paper in the cartridge is noticeably worn, replace the filter with a
new one before further use. We do not recommend the use of pressurised water to clean filters.
3. Replace the filter protector cover over the filter cartridge and attach to the filter connector by
turning it clockwise until hand tight.
To help to keep your water clean, check your filter cartridge every day. To order more filters for your Wave
Spa, please visit
wavespas.com
®
CLEANING & STORING YOUR WAVE SPA
To Next Page
