INSTALLATION GUIDANCE
Indoor Installation
Be aware of special requirements if you install your Wave Spa indoors:
1. The floor must be able to withstand the combined weight of the
Wave Spa and occupants.
2. The floor should be a non-slip, level surface.
3. A suitable drainage solution is essential when installing your Wave
Spa indoors. Please carefully consider the placement of your spa
before installation.
PLEASE NOTE: Do not install the Wave Spa on carpet or other material
that can be damaged by water
Outdoor Installation
1. No matter where you install your Wave Spa, it is important you have a solid support foundation. If you are
installing the Wave Spa outdoors, ensure there are no sharp objects that could damage it and that the location is
level so the Wave Spa sits properly.
2. During filling, emptying or when in use, water may spill out of your Wave Spa. You should install it near to a
drainage point that is able to accept the total volume of water.
3. Do not position your spa in direct sunlight for long periods of time as this may affect the strength of the welds.
Winter Advice
When setting up your spa during the winter or cold periods, follow this advice to prevent damage to the materials, and
extend the life of your product.
1. If the ambient temperature is below 10°C (50°F), we suggest keeping the package indoors, where the
temperature is above 15°C(59°F) for at least 2 hours before unpacking. This will make the spa liner more
flexible and easier to set up.
2. When filling your spa, the water temperature used to fill the spa must be above 5°C (41°F), otherwise the
controler may display an error code.
3. Your Wave Spa comes with Freeze Protect technology to prevent water freezing inside the system. It is possible
to set the controls so that, if the temperature falls below 5°C (41°F), the heater will automatically come on. In
the event of a long-term absence from home when there is a risk of temperatures falling below 5°C (41°F), we
strongly suggest emptying and disassembling the spa, and storing it following the storage advice.
Setup Video
The RCD plug is a trip switch and a key electrical safety feature of your Wave Spa; it should
be tested before each use
1. Insert the plug into the power outlet.
2. Press the <<ON / RESET>> button, the indicator light turns red.
3. Press the <<OFF / TEST>> button, the indicator light turns off.
4. Press the <<ON / RESET>> button again, if the indicator light turns red, the RCD is working properly.
If your RCD plug does not behave in this way, switch off the spa and contact Wave’s Customer Services team.
To Next Page
Loading...
