Name: Waveshare UART TO ETH
Brand: Waveshare
Rating: 5 (1 reviews)

To Next Page

To Previous Page

RS485 TO ETH ( B)

Enable Modbus TCP function

If the user's Modbus TCP software is used as a slave (Slave), you need to change the working

mode to client based on the selection of the conversion protocol, and change the destination IP

to the IP of the computer where the Modbus TCP software is located, and the destination port is

502, as shown in the figure blow.

Modbus TCP as client

22 / 52 www.waveshare.com

Questions and Answers:

Need help?

Do you have a question about the Waveshare UART TO ETH and is the answer not in the manual?

Waveshare UART TO ETH Specifications

General