Model 9100 — Operator's Guide: Error Messages 18-7
Error Messages
18
L
Level too big B
Level too small B
Limits: Gain of 1 zero D
Limits: R-eqV D
Low volt lvl above high volt lvl
The voltage specified for the low level of a pulse
waveform is above that specified for its high level
B
M
Maximum value B
Measurement command flushed
The required internal A/D converter reading
is not available
A
Minimum value B
Minutes entry is not a valid number F
Month entry is not a valid month F
Month entry is not a valid number F
Month separator is incorrect F
MULTIPLE analogue fail flags
More than one analogue failure has been detected
C
N
No A/D ready bit after 160ms
The internal A/D converter has not produced a
reading within the required time period
A
No more failures to view
There are no more self-test failures to be reported
B
No more ranges B
Nominal Resistance too big B
Nominal Resistance too small B
Number too big B
Error Message Error
Type
www.valuetronics.com
To Next Page
Loading...
