Pico
™
on-the-go car seat INSTRUCTION MANUAL
2120
Release fold lock.
Rotate seat bottom to stored position.
NOTE: It may be necessary to unbuckle and loosen harness
to allow seat bottom to rotate to stored position.
Hook fold retention loop onto hook at top of seat back.
Adjust headrest all the way down into stored position.
FOLDING PICO FOR TRANSPORT OR STORAGE
VEHICLE SEAT BELT AND TETHER
If your vehicle does not have the LATCH System, the car seat MUST be secured to the vehicle
using a vehicle seat belt and tether strap if tether anchor is available. Check vehicle owner’s
manual for seating locations recommended for car seat use and location of tether anchorages.
TETHER INFORMATION
If a tether anchor is not available in your vehicle, the
car seat MUST be secured with only the vehicle seat
belt until a tether anchor can be installed.
For those vehicles where tether anchors are not
available, the car seat may be used without the tether,
provided a secure installation can be achieved.
When not in use, store tether in storage area at top of seat back.
Tether MUST always be used when a tether anchor is available.
Check out support videos at
www.wayb.com/pages/support.
Point your smartphone’s camera
directly at the QR Code to activate.
To Next Page
Loading...
