Wayb Pico - LATCH INSTALLATION; LATCH Belt Adjustment; Tether Strap Adjustment

Pico
™
on-the-go car seat INSTRUCTION MANUAL
2322
LATCH INSTALLATION
WARNING
• LATCH belt MUST stay tightly adjusted at all times.
• Tether MUST always be used with lower anchor belt when available.
• Only use the car seat LATCH System in vehicle seating locations
designated by the vehicle manufacturer for use with LATCH and that
have an anchor spacing between 11 in. and 20 in. (280 mm and 508 mm).
Check your vehicle owner’s manual to see if your vehicle allows for
non-standard, other than 11 in. (280 mm), lower anchor spacing.
• Lower anchor belts can be used to attach this car seat when
restraining ALL children whom meet requirements in the “Who
Can Use It” section of this manual (pg. 2).
• LATCH connectors MUST be secured to the vehicle LATCH anchors only. Connection to other
vehicle anchors or vehicle components could result in the connector tearing free in a crash.
• NEVER attach more than one connector to a vehicle lower anchor
unless recommended by the vehicle owner’s manual for that vehicle.
• When installing car seat using LATCH in a seating position that has a lap and shoulder
belt, ALWAYS buckle the lap and shoulder belt and lock the retractor or position the
lap and shoulder belt out of the child’s reach to prevent entanglement.
Refer to vehicle owner’s manual to identify the seating
locations with the LATCH Anchorage System. Select the
seating location to be used and locate the vehicle lower
anchors at the seat bight for that seating location.
Location of some vehicle lower anchors will be
identied by the LATCH Lower Anchor Symbol:
Lower
Anchors
After selecting a seating location, if vehicle seat back is
adjustable, adjust seat back into most upright position
or the position specied in the vehicle owner’s manual.
Set up Pico for use by unfolding and locking into use
position, see “Setting Up Pico” section for assistance (pg. 17).
Check that fold lock is securely engaged.
Lengthen lower anchor belt by pressing adjuster
release button while pulling belt to extend the
length of lower anchor belt.
Remove push-on connectors from the
storage bars on both sides of the car seat.
WAYB strongly recommends installing the Pico with LATCH whenever it is possible to correctly
install with LATCH. The LATCH system generally allows for the easiest installation.
Check out support videos at
www.wayb.com/pages/support.
Point your smartphone’s camera
directly at the QR Code to activate.