Pico
™
on-the-go car seat INSTRUCTION MANUAL
2726
REMOVAL OF PICO INSTALLED WITH LATCH
Check for secure installation. Gripping car seat at the belt
path, pull car seat front to back and left to right to check
for secure installation. LATCH belt MUST stay tight.
Car seat should not move more than 1 in. (25.4 mm).
If LATCH belt does not stay tight or car
seat cannot be securely installed:
Try a dierent LATCH equipped seating position.
Try installing using the vehicle seat belt.
See “Vehicle Seat Belt Installation” section (pg. 29).
Push tether strap adjuster button to loosen tether strap.
Depress retainer spring and unhook tether hook from
vehicle tether anchor.
Loosen lower anchor belt by pressing adjuster button
and pulling out lower anchor belt.
Pressing down in center of car seat to reduce tension on lower
anchor belt will make it easier to loosen lower anchor belt.
Remove push-on connectors from vehicle lower anchors.
Press and hold the red release button .
Pull the connector o the lower anchorage .
Repeat to remove push-on connector on opposite side.
At least 80% of the Pico car seat bottom
MUST be on the vehicle seat bottom.
2
2
1
1
1
1
2
2
WARNING
• DO NOT use the Pico in a vehicle seat that does
not support at least 80% of the car seat bottom.
WARNING
• DO NOT use this car seat if it cannot be securely installed.
To Next Page
Loading...