Pico
™
on-the-go car seat INSTRUCTION MANUAL
3332
Check for secure installation. Gripping car seat at the
belt path, pull car seat front to back and left to right to
check for secure installation. Car seat should not move
more than 1 in. (25.4 mm). Vehicle lap belt MUST stay tight.
If vehicle lap belt does not stay tight or
car seat cannot be securely installed:
Try installing with LATCH. See “LATCH Installation” section (pg. 22).
Try installing in a dierent vehicle seating position.
FOR VEHICLE LAP AND SHOULDER BELTS
Place your hand in center of car seat bottom and use leverage
to compress the car seat into the vehicle cushion while pulling on
the shoulder belt to tighten the vehicle lap belt. Rocking the car seat
from side to side will assist in getting the lap belt tightly adjusted.
NOTE: If your vehicle belt is not equipped with a
switchable retractor or locking LATCH plate, you
may need a locking clip to securely install this car
seat. Contact WAYB at 1-888-924-WAYB (9292) or
email help@wayb.com to request a free locking clip.
If using tether, snugly adjust tether strap by pulling on free end.
NOTE: Check that both sides of the tether are tight.
It may be necessary to pull some strap through the
tether hook toward the adjuster to get both sides tight.
REMOVAL OF PICO INSTALLED WITH VEHICLE SEAT BELT
Push tether strap adjuster button to loosen tether strap.
Depress retainer spring and unhook
tether hook from vehicle tether anchor.
Unbuckle vehicle seat belt.
Pressing down in center of car seat to reduce
tension on vehicle seat belt will make it easier
to unbuckle vehicle seat belt.
WARNING
• DO NOT use this car seat if it
cannot be securely installed.
2
1
1
2
At least 80% of the Pico car seat bottom
MUST be on the vehicle seat bottom.
WARNING
• DO NOT use the Pico in a vehicle seat that does
not support at least 80% of the car seat bottom.
To Next Page
Loading...