Wayne-Dalton 9600 User Manual

9100, 9400, 9600
IMPORTANT NOTICE!
Read these instructions carefully before
attempting installation. If in question about
any of the procedures, do not perform the
work. Instead, have a qualified door agency
do the installation or repairs.
© Copyright 2009 Wayne-Dalton Corp. Part No. 290771 REV4 08/03/2009
Torsion Spring
Installation Instructions and Owner’s Manual
Portland Source Plant
Wayne-Dalton Corp.
P.O. Box 67
Mt. Hope, OH 44660
www.wayne-dalton.com

Wayne-Dalton 9600 Specifications

General

Security	Rolling Code Technology
Type	Residential
Max Door Height	8 feet
Remote Controls Included	2
Warranty	Lifetime motor warranty

Summary

Pre-Installation and Removal

Removing Old Door and Springs

Safety warnings and steps for removing old doors and various spring systems.

Preparing the Opening

Essential steps to prepare the garage opening for new door installation.

Garage Door Installation

Vertical Tracks and Jamb Brackets

Attaching vertical tracks and installing Q.I. jamb brackets.

Door Section Assembly

Installing bottom section, drums, and stacking subsequent door sections.

Operator Mounting Preparation

Installing U-bars and operator brackets for door openers.

Horizontal Tracks and Top Brackets

Installing horizontal tracks and adjusting top brackets for door support.

Torsion Spring System Installation

Mounting bearing brackets, assembling and winding torsion springs.

Rear Support Installation

Installing rear supports for horizontal tracks and final adjustments.

Optional Installations

Security, Access, and Operator Options

Installing side locks, pull ropes, step plates, and trolley operators.

Maintenance and Warranty

Door Care and Appearance

Procedures for cleaning and painting the garage door finish.

Lifetime Limited Warranty

Terms and conditions of the lifetime limited warranty.