Wayne-Dalton Quantum 3314 User Manual (English)

Questions and Answers:

M
Michele CruzAug 22, 2025
What to do if my Wayne-Dalton Garage Door Opener closes and then returns to fully open position?
- S
  Stephen EnglishAug 22, 2025
  If your Wayne-Dalton Garage Door Opener closes and then immediately returns to the fully open position, and the opener light flashes, it could be due to a few reasons. First, check the door arm adjustment; adjust the rod in the tube to allow for about 1 inch of 'cushion' compression when the door is fully closed. Second, the close travel adjustment might be set beyond the normal door position; adjust the close travel with a screwdriver, turning it clockwise. Finally, inspect the floor for any obstructions like stones or ice and remove them.
S
Suzanne PerezAug 23, 2025
Why my Wayne-Dalton Garage Door Opener won’t work from wall button or radio control?
- C
  Courtney JohnsonAug 23, 2025
  If your Wayne-Dalton Garage Door Opener doesn't work when you use the wall button or the radio control, the issue might stem from a few causes. First, there might be no power reaching the opener, so check the cord, outlet, wall switch, and circuit breaker. Second, a short circuit in the wires connecting to the opener or wall button could be the culprit; you can isolate this by disconnecting the wires at the opener from the wall station. Lastly, the Motor Protector might have tripped due to excessive use; allow the motor to cool down for about 20 minutes before trying again.
M
Mercedes McdonaldAug 25, 2025
Why does my Wayne-Dalton Quantum 3314 Garage Door Opener reverse before closing?
- A
  Angela MitchellAug 26, 2025
  If your Wayne-Dalton Garage Door Opener reverses direction before fully closing and the opener light flashes, it indicates that the obstruction sensing system has been activated. This could be due to a few reasons. First, check for any binding in the door's movement, such as issues with the door stopping or the tracks. Second, remove any loose or hanging objects that might be activating the Infrared Safety Sensor. Lastly, the closing force might be insufficient, so you should adjust it.
R
robertmeyersAug 27, 2025
What to do if my Wayne-Dalton Quantum 3314 door does not open and opener light flashes?
- J
  Julian CarrollAug 27, 2025
  If your Wayne-Dalton Garage Door Opener door does not open and the opener light flashes, it could be due to a few reasons. First, there might be something obstructing the door's path, so disconnect the door from the operator and manually operate the door to find any obstructions. Alternatively, call a service person. Second, the opening force might be insufficient, so you may need to adjust it. Finally, a build-up of ice and snow around the door could be the problem, so shovel and clear the area.
X
xsanchezAug 27, 2025
Why Wayne-Dalton Quantum 3314 works from wall button but not remote?
- T
  Tina GuerraAug 27, 2025
  If your Wayne-Dalton Garage Door Opener works from the wall button but not from the radio control, the radio control system may not be working correctly. You can try the following: * Replace the battery in the transmitter if it's weak or dead. * Ensure the Security Code matches between the receiver and transmitter. * If multiple transmitters aren’t working, have the Motor Control Board tested.
A
Alyssa ReedAug 29, 2025
How to fix Wayne-Dalton Quantum 3314 when door stops and does not close fully?
- K
  karen12Aug 29, 2025
  If your Wayne-Dalton Garage Door Opener door stops and doesn't close fully, it's possible that the close limit hasn't been set correctly. To resolve this, adjust the close travel with a screwdriver, turning it clockwise to achieve the desired setting. Note that a 1/4 turn equals 1 inch of travel.
R
Rebecca JohnsonAug 30, 2025
How to fix Wayne-Dalton Quantum 3314 when door does not open fully?
- J
  Jeffrey GarciaAug 30, 2025
  If your Wayne-Dalton Garage Door Opener door does not open fully and the light does not flash, it's likely that the open limit hasn't been set properly. To fix this, adjust the open travel with a screwdriver, turning it counter-clockwise to the desired setting. Remember that 1/4 turn equals 1 inch of travel.
D
Daryl DavisSep 1, 2025
Why does my Wayne-Dalton Quantum 3314 Garage Door Opener close and then reopen?
- A
  April RobinsonSep 1, 2025
  If your Wayne-Dalton Garage Door Opener closes and then returns to the fully open position and the opener light flashes, it could be due to a few reasons. First, the door arm adjustment might be off. Adjust the rod in the tube to provide 1” of “cushion” compression when the door is fully closed. Second, the close travel adjustment may be set beyond the normal door position, so adjust the close travel with a screwdriver. Finally, check for any obstructions like stones or ice under the door and remove them.
M
Michael WilliamsSep 3, 2025
How to fix a Wayne-Dalton Garage Door Opener that won't work?
- J
  Jose SerranoSep 3, 2025
  If your Wayne-Dalton Garage Door Opener won’t work from the wall button or radio control, there could be a few reasons. First, check the power to the opener, wall switch, and circuit breaker. Second, there might be a short circuit in the wires to the opener or wall button, so isolate by disconnecting the wires at the opener from the wall station. Finally, the motor protector may have tripped open due to excessive use, so allow the motor to cool for 20 minutes and try again.
J
Justin JohnsonSep 4, 2025
What to do if Wayne-Dalton Quantum 3314 reverses before closing?
- V
  victoria81Sep 4, 2025
  If your Wayne-Dalton Garage Door Opener reverses travel before reaching the fully closed position and the opener light flashes, it indicates the activation of the obstruction sensing system. Check for any binding in the door travel, such as the door 'stopping' or issues with the door tracks. Also, remove any loose or hanging objects on the door that might be activating the Infrared Safety Sensor. Finally, ensure that closing force is properly adjusted.

Wayne-Dalton Quantum 3314 Specifications

General

Horsepower	1/2 HP
Drive Type	Chain Drive
Voltage	120V
Frequency	60 Hz
Remote Control	Yes
Safety Sensors	Yes
Speed	7 inches per second
Maximum Door Weight	500 lbs
Remote Controls Included	2
Battery Backup	No
Smartphone Control	No
Maximum Door Height	7 feet