CONSTRUCTION
MOTOR HOUSING Stainless Steel
VOLUTE Cast Iron
IMPELLER
Glass Reinforced Thermoplastic
SHAFT Steel
DISCHARGE
1-1/2 in. NPT
PUMP SPECIFICATIONS
POWER SUPPLY REQUIREMENTS 120 V, 60 Hz
MOTOR Single Phase, Dielectric Oil Filled
HORSEPOWER
1/2 HP
CIRCUIT REQUIREMENTS 15 A (minimum)
DIMENSIONS
11-1/2 in. high x 9-3/4 in. base
ON LEVEL (FACTORY SET) Approximately 9 in
OFF LEVEL (FACTORY SET)
Approximately 4 in.
Smart Submersible Sump Pump
Please read and save these instructions. Read carefully before attempting to assemble, install,
operate or maintain the product described. Protect yourself and others by observing all safety
information. Failure to comply with instructions could result in personal injury and/or property
damage! Retain instructions for future reference.
Installation Manual Basement Guardian Halo™
PERFORMANCE GAL/HR
Model HP
Discharge Head (Lift Distance)
0 ft 5 ft 10 ft 15 ft 20 ft
HALO50 ½ 5100 4500 3840 3060 2040
600013-001 B 06/24
© 2024, WAYNE/Scott Fetzer Company
www.waynepumps.com
CONTROLLER SPECIFICATIONS
SWITCH Solid State Air Switch
CONNECTIVITY Wi-Fi + BLE
AIR TUBE
PVC
Scan the QR code or visit www.waynepumps.com for the full manual in English and Español. If you are having trouble scanning the
QR code, type the following URL into your internet browser to access the manual, www.waynepumps.com/wayne-operating-manuals/
To Next Page
Need help?
General
