READ THIS MANUAL BEFORE YOU BEGIN
Dispensers have both electricity and a hazardous, flammable, and potentially explosive liquid. Failure
to follow the below precautions and the Warning and Caution instructions in this manual may result in
serious injury or death. Read every tag attached to the dispenser before commencing installation.
Follow all rules, codes, and laws that apply to your area and installation.
SAFETY PRECAUTIONS - INSTALLATION AND MAINTENANCE
Always make sure ALL power to the dispenser is turned OFF before you open the dispenser cabinet
for maintenance. Physically lock, restrict access to, or tag the circuit breakers you turn off when
servicing the dispenser. If applicable, be sure to trip (close) the emergency valve(s) under the
dispenser BEFORE beginning maintenance.
Make sure that you know how to turn OFF power to the dispenser and submersible pumps in an
emergency. Have all leaks or defects repaired immediately.
EQUIPMENT PRECAUTIONS
Be sure to bleed all air from the product lines of dispensers pumps before dispensing product,
otherwise, damage to the equipment may occur. Always use the approved method for lifting the
dispenser. Never lift by the nozzle boot, sheet metal, etc., otherwise equipment damage or personal
injury may occur.
USE ONLY GENUINE PARTS
For product liability to be valid, no changes may be made to the equipment without the written
consent of Wayne.
REGISTRATION OF SITE AND HOW TO CONTACT WAYNE
The equipment used at this site must be registered prior to contacting Wayne for warranty service.
Sites can be pre-registered prior to installation by a Wayne Authorized Service Organization (ASO)
via the on-line registration system OR through completing the Section 1 portion of the form, at the end
of this manual, and sending it to Wayne (for non-ASOs). Pre-registration of a site helps to expedite
warranty service in case it is needed. Please allow 2-3 days after receipt of the information for pre-
registration. Final registration, which requires all of the information pertaining to the site including
Start-Up date and equipment serial numbers, must be completed within 7 days of the completion of
the Start-Up using the same aforementioned methods.
Trouble with the installation of this product should be referred to your Wayne
®
ASO. An ASO with a
technician number can receive assistance by calling Wayne at Technical Support at:
1-800-926-3737
Customers, Installers or Distributors who are not an ASO, needing help with the operation or
installation of this product, should contact the Wayne Help Desk at:
1-800-289-2963 OR support@wayne.com
INDICATORS AND NOTATIONS
Danger indicates a hazard or unsafe practice which, if not avoided, will result in severe injury or
possibly death.
Warning indicates a hazard or unsafe practice which, if not avoided, may result in severe injury
or possibly death.
Caution indicates a hazard or unsafe practice which, if not avoided, may result in minor injury.
Important information to consider, otherwise, improper installation and/or damage to
components may occur.
NOTE:
DANGER
WARNING
CAUTION
DANGER
To Next Page
Loading...
