Webasto AT2000STC - Digital Controller Setup and Use; Initial Controller Configuration; First-Time Heater Activation

WebastoAirTopInstallationGuide–AT2000STC

17
AirTop2000STCInstallationGuide2020|WebastoThermo&ComfortAustraliaPtyLtd.

10Multi‐ControlSet‐Up&OperationsGuide
10.1Set‐Up

InitialStart‐Up
WhentheControlunitisconnectedforthe firsttime,amessageabouttheSetting/Configurationoftheheateris
dis
p
la
y
ed.
1 MenuName
2 MenuSymbols
3 TimeSettingActivated
4 Time
5  On/OffButton
6  ControlKnob
Timer
Heating
Ventilation
Settings
PressthecontrolknobandtheOn/OffButtonsimultaneouslyfor3seconds
SelectyourHeater(Note:AirTopEvo40/55isdisplayedasAT40/55)
PresstheControlKnob
SelectthecurrentDay
PresstheControlKnob
SelectthecurrentTime‐turntheControlKnobclockwisetoselectHour,presstheControlKnobto
confirm,thenturntheControlKnobclockwiseagaintoselecttheMinutes,presstheControlKnobto
set.
PresstheControlKnob