Need help?Do you have a question about the Webasto AT2000STC and is the answer not in the manual?
General| Fuel Type | Diesel |
|---|---|
| Voltage | 12V |
| Heater Type | Air |
| Heating Power/Capacity | 2.0 kW |
| Control | Digital Timer |
Explains the intended use of the Air Top 2000STC heater for various vehicle cabins.
Covers optimal location, ducting length, and return vent requirements for the heater.
Details positioning for electrical, fuel, exhaust, and combustion air systems.
Guides on fuse usage, battery connection, and fuel source selection.
Recommends loosely attaching the heater for layout predetermination and easy access.
Specifies correct placement of serial number labels for accessibility and warranty validation.
Presents dimensions and an image of the floor mounting bracket for proper installation.
Details attaching the heater to the mounting bracket using the gasket and supplied hardware.
Explains the main harness, fuse holder, and battery connections essential for heater operation.
Details connecting the 620 Ohm resistor for temperature sensing to prevent error codes.
Explains fuse types (F1, F2) and their correct amperage for heater and controller power.
Guides on connecting the 7m fuel pump harness to the pump and wiring loom.
Explains installing the multi-control or rotary controller in a suitable, accessible location.
Describes installing the fuel pump with bracket, clamp, and elbow to minimize vibration.
Details fitting the fuel stand pipe into the tank, ensuring correct length and positioning.
Explains installing the fuel filter between the fuel source and pump for combustion purity.
Illustrates a single hot air outlet ducting setup for efficient heat distribution.
Shows a twin outlet ducting setup, including Y-junction and air outlets.
Describes the startup sequence, audible cues, and initial hot air delivery.
Explains the proper method to turn off the heater via the controller, not main power supply.
Provides a method for bleeding the fuel line and troubleshooting F01 fault codes.
Details the procedure to reset the controller, involving fuse removal and power cycling.
Guides through the initial setup, including selecting the heater model and setting the current time/day.
Explains the process for selecting the heater and setting the current day and time.
Details programming up to 3 daily timers (21 weekly) for automatic heater operation.
Explains how to activate and deactivate the altitude function for operation at higher elevations.
Instructs how to identify fault codes by counting slow flashes on the rotary control indicator.
Lists fault codes, messages, details, and recommended troubleshooting for common heater errors.
Details fault codes F12 through F15, including their causes and recommended remedies.
Explains fault codes displayed on the digital multi-control, with messages and required actions.
Lists fault codes 12 through 1A for the digital multi-control, with causes and solutions.
Provides links to YouTube tutorials for heater setup, operation, and troubleshooting assistance.
Lists digital controller error codes, their descriptions, and recommended fault remedies.
To Next Page