Webasto BlueCool S Series - Overview of Programming Functions; Entering setting levels

BlueCool S Series 10 Overview of Programming Functions
31
10 Overview of Programming Functions
Table 2 Operating structure
Operating level Setting level 2 Setting level 3
On On On
1-5, A
Display
setpoint
temperature
15-29 °C
b Fan speed
Setpoint temperature 15 °C,
59 °F
Setpoint temperature 29 °C,
85 °F
E
Evaporator
temperature
Off Off
Access code simultaneously and simultaneously and
Setting level 1 Access code Access code
F
Operating
mode
0(x)
Undervoltage
switch-off
u(x) Temperature unit
U
Operating volt-
age
1(x)
Activation or deac-
tivation of IR
remote control
0(x)
Switch-off temper-
ature for compres-
sor cooling
minimum
Fd
No. of dehu-
midification
cycles
2(x)
Fan type (AC, EC,
electronic silencer)
1(x)
Switch-off temper-
ature for compres-
sor cooling
hd(x)
Heating time in
dehumidifica-
tion cycle
3(x)
Thermostat-con-
trolled fan or per-
manently switched-
on fan
2(x)
Switch-on temper-
ature compressor
cooling
cd(x)
Cooling time in
dehumidifica-
tion cycle
b5 Fan speed 5 3(x)
Switch-off temper-
ature compressor
heating
Temp
Room temper-
ature
b4 Fan speed 4 4(x)
Switch-on temper-
ature compressor
heating
b3 Fan speed 3 5(x)
Switch-on/switch-
off hysteresis com-
pressor
b2 Fan speed 2 6(x)
Correction value of
displayed room
temperature
b1 Fan speed 1 7(x)
Maximum time dur-
ing which the evap-
oration
temperature may
be below Parame-
ter 1, “Switch-off
temperature, com-
pressor cooling”
c(x) Access code 8(x) Firmware version
Display of room temperature Display of room temperature