VW Passat
5
General References
– Bare body parts, for example around drilled holes, must be treated with anti-corrosive coating.
– Secure hoses, cables and wiring harnesses with cable ties and fit protective hoses around them at chafing
points.
– Fit edge protectors (opened fuel hose) to sharp edges.
Preparation
Heater Kit
– Verify and identify all contents of kit.
Vehicle
– Verify fuel content in tank.
– Remove underbody splash shields.
– Remove bulkhead cowl panel.
– Remove windshield wiper arms.
– Remove fuel tank splashshield.
– Remove engine cover.
– Remove air intake tube.
CAUTION
For reasons of safety due to possible fuel spillage, it is recommended that there be no more than 1/2 tank of fuel
present. If fuel quantity is greater than 1/2 of capacity, make provisions to reduce quantity of fuel.
– Disconnect negative terminal of vehicle battery(s).
– Protect vehicle fenders, panels and interior with covers
Heater Installation Site
ATTENTION
The Webasto Auxiliary Coolant Heater is installed on
the left side of the engine next to the vehicle ABS unit.
– (1) Webasto Auxiliary Coolant Heater (Installed)
1
Fig. 1
BlueHeat
TM
To Next Page
Loading...
Need help?
General