21
GB
Operation
The operation of the clock is designed so that all flashing symbols can be
ad-justed using the and buttons. The displayed time is stored if no button
is pressed for 5 seconds. Pressing the and buttons for longer than
2 seconds causes the display to change rapidly.
If the ignition is switched off while the heater is operating in continuous heating
mode, the display shows a remaining operating time of 15 minutes and the
heater continues to operate.
Switching on
Manual: Press the button (continuous heating mode).
Automatic: By programming the start of heating.
Switching off
Manual: Press the button .
Automatic: By programming the operating time when the heater is operating:
By setting the remaining operating time.
Setting the time/day
Press the button for longer than 2 seconds – the time flashes – press the
and buttons to set the time – the day of the week flashes – set the day
of the week.
2010_2016_BA.book Seite 21 Dienstag, 24. Mai 2005 9:48 09
To Next Page
Loading...
