What to do if my Webasto Heater shuts down due to faults during heating operation?
If your Webasto heater shuts down during operation, it could be due to several factors. Check the metering pump for proper functioning. Also, verify the ambient temperature to ensure the motor isn't overheating, and inspect the safety switch.
How to fix Webasto HL 24 D if it shuts down in 'fault lock out' mode?
If your Webasto heater is in 'fault lock out' mode, try the following: switch on the heater, charge the battery, check and replace fuse F2 if necessary, check electric leads for earth connection and short circuit, replace fuse F1 if necessary, check electric leads and connections for the glow plug, check electric leads for interruptions, check the flame detector and electric leads for earth connection and short circuit, check the safety thermostat and safety switch, and check the metering pump for proper functioning.
Why does my Webasto HL 24 D Heater give off too little heat?
If your Webasto heater isn't providing enough heat, there could be several reasons. A wiring fault could be the cause, so you should check the exhaust silencer and exhaust pipe. You might also need to check the delivery rate of the metering pump, adjust the CO value (check installation location or speed), clean the heat exchanger, replace the matting, check the drive unit, voltage, and combustion air and fuel quantities.
Detailed technical specifications for HL 24/32 and Air Top 24/32 heaters.
Describes the components and operation of the HL 24/32 B/D heater.
Explains the step-by-step operation for various control units and modes.
Covers control units, resistors, relays, and wiring harnesses.
To Next Page
General