Weber mt CR 6 - Exciter Oil Change Procedure; Fuse Replacement Procedure; Using a Permanent Battery Charger

30
8.2.9. Change the oil in the
exciter
Start the engine and allow the engine to warm up for a few
minutes.
Switcho󰀨theengine.
Tilt the machine slightly.
Place a suitable collection vessel under the machine.
Loosen the oil drain plug (1).
Allow the oil to drain.
Tilt the machine in the other direction.
Fillfreshoilintotheexciterinaccordancewiththespecication.
Close the oil drain plug.
8.2.10. Change the fuses
Open the maintenance cover.
Remove the protective caps (1) of the fuse holder.
Replace defective fuses.
Attach the protective caps to the fuse holder.
Close the maintenance cover.
8.2.11. Use a permanent
charger
Open the maintenance cover.
Open the protective cover (1) of the charging socket.
Connect the permanent charger to the charging socket.
Connect the permanent charger to the appropriate mains
supply.
Comply with the manufacturer's operating manual
when using the permanent charger! The operating
manual is included with every permanent charger.
1
1