Weber Rescue Systems SPS 270 MK2 E-FORCE 2 - Lifting; Pressing (Rescue Cylinder)

Topreventthebladesfrombeingdamaged,theymustalwaysbeplacedatrightanglestothe
materialtobecut.Also,thepsofthebladesmustnotbemorethan5mmapartduringthe
cungprocess.Ifthisvalueisexceeded,thecungprocessmustbestoppedandthenstarted
again.

Donotseveranypartswithlooseends,becausethiscanresultinpersonal
injuryduetopartsyingo.

Whencunghigh-strengthvehiclebodyparts,suchasshockabsorbers,
hingesorsteeringcolumns,theshearblades(arms)maycausesevere
damage.
5.3Liing/pressing(rescuecylinder)
Initsclosedstate,therescuecylinderisposionedforliingorpushingawayvehiclebody
parts.Therefore,makesurethatthecylinderisplacedascentrallyaspossibleandataright
angle to the load.
Forbeerposioning,thepushingheadcanbeturnedonthepistonrod.
Suspendedpartsmustimmediatelybesuitablybracedandsupported.Itisforbiddentostay
under suspended loads.

Beforetherescuecylinderisused,theaachmentpointmustbesupported
sothatforcedevelopsinthedesireddirecon.
