Weber Rescue Systems SPS 270 MK2 E-FORCE 2 - Malfunctions




  
Devicedoesnotreachfullperformance
Rockerleversnotcompletelypressed
to the side
Presstherockerlevercompletelyto
the side
Combidevicemovesinopposite
direconunderload
Checkifvalveisdefecve
Havethedevicecheckedby
anauthorizedservicecentre.
Blades are loose and gape apart during
cung
Bladenotaachedtothecuerhead
asspecied
Haverepairedbyanauthorized
workshop
Blade opening below target value Cuerheadsengsaltered
Haverepairedbyanauthorized
workshop
Combidevice'sopeningwidthbelow
target value
Cuerheadsengsaltered
Haverepairedbyanauthorized
workshop
Pressurebuild-updespitemovement
(open–closed)withoutload
Hexnut/central
bolttooght
Haverepairedbyanauthorized
workshop
Blade chipping
Bladesdamagede.g.fromcunghigh-
strength materials
Regrindabletoabout2mm,seerepair
manual,otherwisereplace
Cracksintheblades
Bladesdamagede.g.fromcunghigh-
strength materials
Havethebladesreplacedby
anauthorizedservicecentre
Rescueequipmentdoesnotfuncon Baeryisdead
Placethebaeryonthecharger.The
displaysonthebaeryandchargergive
informaonaboutthebaerycharge
status.