EasyManua.ls Logo

Weber Rescue Systems SPS 270 MK2 E-FORCE 2 - Intended Use; Power Line Connection; Li-Ion Battery

Default Icon
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6.3Intendeduse
Thischargerchargesthe28VLi-ionbaeryoftheM8/V28systemdeliveredwiththebaery-
powereddevice.Thisdevicemustbeusedonlyasspeciedandintended.
6.4 Powerlineconnecon
Onlyconnecttosingle-phaseACcurrentandonlytothelinevoltagespeciedonthetype
plate.Connecontopowersocketswithoutanearthingcontactispossible,becausethisisa
proteconclassIIdesign.
6.5 Li-ionbaery
Forsafetyreasons(airtransportregulaons),thebaeriesaredelivereduncharged.Beforerst
use,thebaerymustbecompletelycharged.
LEDchargestatusdisplay Figure1
Ifthebaeryisnotusedforaprolongedperiodofme,thebaeryswitchestostandbymode.
Touseagain,thebaerymustbereacvated(recharged).
Thechargestatuscanbecalledupbypressingthebuononthebaery(seeFig1).Todothis,
thebaerycanremaininthebaery-powereddevice,butitmustbeswitchedoatleast1
minutebeforehand(otherwisethedisplaywillnotbeaccurate).ThenumberofglowingLEDs
indicates the charge status.
Thebasicprincipleis:Ifthebaery-powereddevicedoesnotfunconaerthebaeryis
inserted,putthebaeryontothechargerfortesng.Thedisplaysonthebaeryandcharger
giveinformaonaboutthebaerychargestatus.
Atlowtemperatures,theworkcanbesllbecarriedoutwithlowerperformance.
Forbestoperaonalreadiness,thebaeriesmustbefullychargedaeruse.


Table of Contents

Related product manuals