Weber E/S 650 - User Manual

Questions and Answers

Y
ycampbellAug 11, 2025
What to do if my Weber Grill burner does not light or has a small flickering flame?
- S
  Stacy GreenAug 12, 2025
  The excess flow safety device may have activated. To reset it, turn all burner control knobs and the cylinder valve to “OFF”. Disconnect the regulator from the cylinder. Turn burner control knobs to “START/HI”. Wait at least one minute. Turn burner control knobs to “OFF”. Reconnect the regulator to the cylinder. Turn the cylinder valve on slowly. Refer to “Lighting Instructions”.
G
gatesbrandonAug 21, 2025
How to fix a Weber E/S 650 Grill rotisserie burner that doesn't light?
- B
  Brenda FrenchAug 22, 2025
  Try the following: 1. Relight the burner by holding the burner control knob in and continue holding it in until 20 seconds after the burner has ignited. 2. When relighting the burner by holding the burner control knob in, wait to see the entire ceramic surface become alight before counting 20 seconds. 3. After waiting five minutes for the gas to clear, try repeatedly using the snap igniter until the burner ignites (refer to “Lighting the Rotisserie Burner”). 4. Try manually lighting the burner (refer to “Lighting the Rotisserie Burner”).
G
Gabriel MilesAug 31, 2025
Why is my Weber Grill Out™ Handle Light not working?
- L
  laurie28Aug 31, 2025
  There are several possible reasons: * The batteries may be old, replace them. * The batteries may be installed incorrectly, check the assembly illustration. * The lid may not be open with the power button on; the light activates when the lid is open. * The Weber Grill Out™ Handle Light may not be activated, press the power button. * The Weber Grill Out™ Handle Light may not be positioned correctly on the handle, adjust the position (see assembly illustration).