Weber Genesis Silver C User Manual

C-3
(1)
Install the work surface
You will need: work surface.
Place the work surface, so that the front and back
edges fit over the frame, in the area between the left
trim piece and the cooking box as shown.
Do not use the work surface as a cutting board.
(1) Make sure that the tabs on the side table are to the
right, next to the cooking box.
Install side burner
You will need: side burner,
 WARNING: Make sure gas supply is off.
Start the side burner hose into the opening between
the control panel and right trim piece route the hose
between the cylinder panel and wheel frame.
Set the side burner in place in the frame. The side
burner locking clip on the right should latch under the
right trim piece.
Tilt the side burner slightly, toward the control panel.
Latch the side burner locking clip on the left, under the
control panel.
Push side burner control knob onto the valve

Weber Genesis Silver C Specifications

General

Grill Type	Gas
Main Burners	3
Dimensions	64 H x 60 W x 30 D (inches)
Fuel Type	Liquid Propane
Ignition System	Electronic
Ignition	Electronic
Material	Porcelain-enameled, cast-iron cooking grates