To connect an additional iGrill
2
(or other iDevices product) device to your iPad,
iPhone or iPod touch follow these steps:
• While turned on, place your iGrill
2
(or other iDevices product)
next to your Apple device and open the iDevices Connected app.
• Tap on the grey bar located at the top of the screen to expose the
device menu. Select the product you would like to pair with from the
device menu. Your Apple device will display a pairing request. Once
accepted, your Apple device will pair with the additional product and
you are ready to configure your settings and start grilling!
3.5 Mounting
• The iGrill
2
’s base is magnetic for convenient positioning on a cool
portion of your grill, smoker or other magnetic surfaces.
• The iGrill
2
can be taken out of its base, rotated 180° and placed back
into its base for two different viewing angles.
• The iGrill
2
comes with an optional magnetic disc with adhesive on one
side. This allows the iGrill
2
to magnetically mount to a non-magnetic
surface. The magnetic disc has a protective cover on its face to protect it
from being scratched.
To mount your magnetic disc, please follow the below steps:
• Clean the surface thoroughly where the magnetic disc will be adhered to
ensure proper bonding.
• Remove the film covering the adhesive on the magnetic disc (not the
scratch protection film on the face of the disc).
• Adhere the magnetic disc to your desired surface.
• Let the magnetic disc bond to the surface for at least 24 hours before
mounting the iGrill
2
to it.
NOTE:
• The base of the iGrill
2
is not designed to withstand high heat and it
must be placed on a cool surface. If the surface is too hot to touch, it’s
too hot for the base!