6
GETTING STARTED
m IMPORTANT: We recommend that you replace the
gas hose assembly on your gas barbecue every
five years. Some countries may have requirements
that the gas hose be replaced within less than five
years, in which case that country’s requirement
would take precedence.
For replacement hose, regulator, and valve
assemblies, contact the Customer Service Team
using the contact information on our website.
Visit weber.com.
A
E
ULPG Cylinder Installation
Regulator Connections
Requirements for Cylinders
• Any parts sealed by the manufacturer must not be altered
by the user.
• Any modification of the appliance may be dangerous.
Additional Requirements for Cylinders
• Avoid kinking the hose.
• Change the flexible hose when national regulations stipulate
this as a requirement.
• Only a nationally approved low-pressure hose and regulator
must be used.
• Replacement regulator and hose assemblies must be as
specified by Weber-Stephen Products LLC.
Connecting and Routing the Gas Hose
1) Attach the male fitting of the gas hose to the regulator
with the BOM/CGA600 connection. Tighten by turning the
fitting clockwise (A). Hand tighten only.
CAUTION: While using the gas hose, use care to route the gas
hose away from the cookbox and other hot surfaces.
Only use the hose assembly as supplied with this appliance
for connection to the cylinder - DO NOT USE ADAPTORS.
Cylinder Requirements
• Use cylinders with a maximum capacity of 8.5 kg.
Inspect the Cylinder
Check the ULPG cylinder before use to ensure a proper gas
connection.
• Confirm that the ULPG cylinder valve is fully closed. Close by
turning valve clockwise.
• Inspect the ULPG cylinder valve for damage or debris. Take
special notice of the condition of the internal O-ring (B). If
damaged, return ULPG cylinder to local retailer.
• Confirm that the ULPG cylinder valve is the proper mating
type for the gas hose (C).
Cylinder Installation
1) Place the ULPG cylinder on the ground behind and to the
right side of the barbecue (D).
2) Turn the ULPG cylinder so the opening of the valve faces
the side or back of the barbecue.
Connect the Gas Hose to the Cylinder
1) Check that the burner control knob is in the
o position. Check by pushing in and turning knob
clockwise.
2) Connect the gas hose coupling to the ULPG cylinder.
Hand tighten only. Using a wrench could damage the
regulator coupling and could cause a leak.
a) Tighten by turning the fitting clockwise (E).
B
12” (305 mm)
m WARNING: Avoid tipping hazard. Position the LPG
cylinder behind barbecue on the right-hand side.
ULPG Cylinder
Position
D
C
To Next Page
Loading...
