Weber SLATE - Page 7

• Regularly inspecting the burner ports and
gas hose is important for safe and optimal
performance.
• Clean the burner ports with a stainless-steel
bristle brush to remove any debris that might
block the flame.
• Inspect the gas hose for cracks, cuts, or wear.
If it’s damaged, don’t use the griddle until
you’ve contacted Weber for a replacement
hose—safety first!
• The Weber
®
Slate GPD 76cm Premium Griddle
works with LPG-Propane gas. The 43cm and
56cm Weber
®
Slate Premium Griddles work with
smaller canisters. These bottles and canisters
can be purchased from your local gas centre,
garden centre or petrol station.
• To connect the regulator to the cylinder. Check
that all burner control knobs are in the off
position. Check by pushing in and turning the
knobs clockwise.
• Every time you swap over your gas bottle or
replace your hose, you should perform the
soapy water test to check the gas connection
and ensure there are no leaks. Once the LPG
cylinder is properly installed, it is necessary
to perform a leak check. A leak check is a reliable
way to verify that gas is not escaping after you
connect the cylinder.
• Ensure you clean the grease pot after each use
to prevent flare-ups.
Essential safety tips
We do not recommend
modifying the BBQ as
this will void the
warranty, as we
cannot guarantee user
safety when using
third party products.
SAFETY
ESSENTIALS
View detailed
information
on installation
and gas leak
checks ›
Getting Started
7
Quick-Start Guide