Weber SMOKEFIRE EX4 - Reassembling Auger;Motor and Connections

22
TROUBLESHOOTING
L
M
N
O
13. Reinstall the auger/motor assembly by slowly and carefully sliding it
back into the grill and securing it with two screws (L), (M).
NOTE: Use care to avoid tearing the auger tube gasket when reinstalling the
auger/motor assembly. If damaged, replacement gaskets can be ordered by
contacting a WEBER Customer Service representative in your area using the
contact information on our website.
14. Connect the motor’s electrical connection. Make sure the connector is
securely joined to the motor (N).
15. Reinstall the rear access panel (O).
Continued...