weBoost Office 200 - Specifications

20
CELL SIGNAL BOOSTER (DIRECTIONAL/PANEL) OFFICE 200
ENGLISH
______
Specifications
Office 200
™
Model Number 460047
FCC ID
PWO460047
IC ID
4726A-460047
Connectors N-Female
Antenna Impedance 50 Ohms
Frequency
698-716 MHz, 729-756 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
Power output for single cell
phone (Uplink) dBm
700
MHz
Band12/17
700
MHz
Band13
800
MHz
Band 5
1700
MHz
Band 4
1900
MHz
Band 2/25
24.0 24.0 25.0 25.0 25.0
Power output for single cell
phone (Downlink) dBm
700
MHz
Band12/17
700
MHz
Band13
800
MHz
Band 5
2100
MHz
Band 4
1900
MHz
Band 2/25
15.1 15.1 15.3 15.2 15.2
Noise Figure 5 dB nominal
Isolation > 90 dB
Power Requirements
120V AC 0.5A
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without
factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in
order to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce
gain until a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation,
the Signal Booster will automatically turn the power o on that band. For a detected oscillation the Signal Booster will automatically
resume normal operation after a minimum of 1 minute. After 5 (five) such automatic restarts, any problematic bands are permanently
shut o until the Signal Booster has been manually restarted by momentarily removing power from the Signal Booster. Noise power,
gain, and linearity are maintained by the Signal Booster’s microprocessor.
The term “IC” before the radio certification number only signifies that Industry Canada technical specifications were met. This device
complies with Part 15 of FCC rules. This device contains licence-exempt transmitter(s)/receiver(s that comply with Innovation, Science
and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference, and (2)) This device must accept any interference, including interference that may cause undesired
operation of the device. Changes or modifications not expressly approved by weBoost could void the authority to operate this
equipment.
NEED HELP?
weboost.ca 1-866-294-1660