8
5. Orient one of the Uprights (3) as shown, and
attach it to the left Upright Base (2) with two M8
x 68mm Bolts (24), two M8 Washers (23), and
two M8 Locknuts (22). Note: The Bolts must
be attached to the lowest set of holes in the
Upright and the Upright Base. Make sure
that the bolt heads are in the hexagonal
holes in the Upright Base. Do not tighten the
Locknuts yet.
Attach the other Upright (3) to the other
Upright Base (2) in the same way.
3
3
2
5
2
22
23
23
24
4. Attach a Support (4) to one of the Stabilizers (1)
with the two indicated M8 x 68mm Carriage
Bolts (20) and two M8 Locknuts (22); do not
t
ighten the Locknuts yet.
N
ext, attach the Support (4) to the Upright Base
(2) with two M8 x 75mm Bolts (17), two M8
Washers (23), and two M8 Locknuts (22); do
not tighten the Locknuts yet.
Attach the other Support (4) to the other
Stabilizer (not shown) and the other Upright
Base (2) in the same way.
4
1
22
22
20
17
23
23
22
22
2
4
2
4