25
This section explains how to adjust the weight system. Refer to the accompanying exercise guide to see the cor-
r
ect form for each exercise.
Make sure that all parts are properly tightened each time the weight system is used. Replace any worn parts
immediately. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not
use solvents.
CHANGING THE WEIGHT SETTING
To change the weight setting of the weight stack,
insert the Weight Pin (70) under the desired Weight
(19). Make sure to insert the Weight Pin until the bent
end of the Weight Pin is touching the Weights, and
turn the bent end upward.
Note: The weight system
works best when at least two Weights are used.
66
49
19
70
ATTACHING THE ACCESSORIES
To attach the Lat Bar (63) to the Lat Cable (49),
attach a Weight Clip (66) to the Lat Cable and the Lat
Bar. Note: For some exercises, you will need to
attach the Chain (not shown) to the Weight Clip
and use another Weight Clip to attach the Chain
to the Lat Bar.
Attach the other accessories to the weight system
in the same manner.
63
ADJUSTMENTS
To Next Page
Loading...
Need help?
General
