Weider FLEX CXT 1112 - Machine Screw

WEIDER
HEALTH
and
FITNESS
Aro
PAGE
7
STEPS
BACKREST
MOUNTING
PLATE
&
BRACE
ASSEMBLIES
|
ary
|
PARTNAME 10: 2
22 5/16" NYLON LOCK NUT
24 5/16" X 3 1/4" HEX HEAD BOLT
26 1/4" NYLON LOCK NUT
28 1/4" X 2" CARRIAGE BOLT
29 1/4" FLAT WASHER
[66 5/16" X 2" HEX HEAD BOLT нэ
[C] Attach the front BACKREST MOUNTING
PLATE (9) to the front hole in the BACKBONE
(3) by bolting with a 1/4" X 2" CARRIAGE BOLT
(28) down through the Mounting Plate and then
through the BACKBONE (3). Assemble a 1/4“
FLAT WASHER (29) onto the bolt and secure
with a 1/4" NYLON LOCK NUT (26).
C] Assemble the rear BACKREST MOUNTING
PLATE (9) to the rear hole in the BACKBONE
(3) by botting with a 1/4" X 2" CARRIAGE BOLT
(28) down through the Mounting Plate, the
Backbone, and then through one end of the
BACKBONE BRACE (10). Secure with a 1/4"
NYLON LOCK NUT (26).
C]
то
attach
the
STEPPER
BRACE
(11),
place
a
p
5/16"
X
3
1/4"
HEX
HEAD
BOLT
(24)
through
the
slotted
curled
end
of
the
STEPPER
BRACE
(11),
then
through
the
MAIN
FRAME
(1),
and
then
the
BACKBONE
BRACE
(10).
Secure
with
a
5/16"
NYLON
LOCK
NUT
(22).
L] Fasten the lower end of the STEPPER BRACE
(11) to the REAR BASE (2) by bolting with a
5/16" X 2" HEX HEAD BOLT (66) up through
the Rear Base and then through the Stepper
Brace. Secure with a 5/16" NYLON LOCK NUT
(22).
ЭМ"
STEP
6
BACKREST
ASSEMBLY
PART NAME
44 RUBBER LEG CURL BUMPER
64 1/4" X 1/2" ROUND HEAD SCREW
65 5/32" X 1/2" MACHINE SCREW
(0 Position BACKREST (12)
onto the BACKBONE (3) so
that the mounting holes in the
brackets align with the holes
in the underside of the
Backrest. Bolt in place using
four 114" X 1/2" ROUND
HEAD SCREWS (64).
O Fasten the RUBBER LEG
CURL BUMPER (44) to the
front of the BACKBONE
LEG (3) with a 5/32" X 1/2"
MACHINE SCREW (65).